How to maintain the fiber laser cutting machine daily?

In order to ensure the normal use of the fiber laser cutting machine, it is necessary to maintain the machine equipment on a daily basis. Since the whole machine adopts high-precision parts, it must be very careful in the daily maintenance process, strictly follow the operation rules of each part, and maintenance should be carried out, and no brutal operation is allowed to avoid damage to the parts. Extend the life of the machine.

 

1. Lubrication System Maintenance

 

Please clean the dirt on the guide rails and racks of sheet metal cutting machine before performing automatic lubrication, and then automatically lubricate the rails and racks once a week to prevent rust and serious wear of the guide rails and racks, and prolong the service life of the machine (recommended to use lubricating oil 48# or 68#).

2. Cooling System Maintenance

 

The circulating water of the chiller must use pure water, and water containing minerals cannot be used. The mineral water is prone to solid crystallization or solid impurities precipitation. Prolonged use can lead to clogging of the water system and cutting machine components (such as metal filters, cutting heads), seriously affecting cutting results, and even burning optical components. (It is recommended to change the purified water for the water cooler once a week)

 

If the cnc metal cutting machines is not at room temperature, it is recommended to set the cooling temperature of the water cooler to 25-30 degrees Celsius in summer. In winter, it is recommended to use coolant to prevent the water cooler and optical fiber from being damaged due to freezing, and to prevent the cooling water pipes from freezing. Please drain the coolant in the water pipes in time.

 

The internal dust removal of the chiller of the cnc laser cutting machine for metal cutting should be carried out regularly. Since the chiller fan blades are protruding, it is easy to accumulate thick dust. After removing the dust cover from the chiller, blow it with air from bottom to top for cleaning. The chiller filter should be replaced every six months.

 

3. Blower Maintenance

If the fan is used for a long time, a lot of solid dust will accumulate in the fan, which will make the fan generate a lot of noise, and is not conducive to exhaust and deodorization. When the suction power of the fan is insufficient and the smoke exhaust is not smooth, first turn off the power, remove the air inlet and outlet ducts on the fan, remove the dust inside, then turn the fan upside down, and pull the fan blades inside until it is clean. , and then install the fan.

 

4. Exercise System Maintenance　　

After the steel laser cutting machine runs for a long time, the screws and couplings at the moving joints may become loose, which will affect the stability of the mechanical movement. Therefore, during the operation of the machine, it is necessary to observe whether there are abnormal noises or abnormal phenomena in the transmission parts, and find problems in time. Sturdy and maintained. At the same time, the machine should tighten the screws one by one with a tool over a period of time. The first firming should be about a month after the device is used.

 

Regular maintenance of laser cutting metal fiber 2000w can not only save economic costs, but also increase the service life of the machine. Therefore, paying attention to maintaining the fiber laser cutting machine at ordinary times can lay a good foundation for future use.